CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to CCS Technical Support
bootloader help

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
sohailkhanonline



Joined: 06 Mar 2008
Posts: 35
Location: pakistan

View user's profile Send private message Visit poster's website Yahoo Messenger MSN Messenger

bootloader help
PostPosted: Fri May 16, 2008 1:23 am     Reply with quote
hi
I am using tiny bootloader for my application i have followed all the steps of the post
http://www.ccsinfo.com/forum/viewtopic.php?t=34065&highlight=tiny+bootloader

The device i am using is 18F4620 with clock of 20MHz
and the hex file in the directory \picsource\18f
tinybld18F2620.HEX

as my device was not listed then i changed the following
in the file icdpictypes.inc

previously
Code:
IFDEF __18F2620
      #include "p18f2620.inc"
IdTypePIC = 0x4F
      #define max_flash 0x10000
   ENDIF
   IFDEF __18F4620
      #include "p18f4620.inc"
IdTypePIC = 0x4F
      #define max_flash 0x10000
   ENDIF

changed
Code:
IFDEF __18F2620
      #include "p18f2620.inc"
IdTypePIC = 0x4F
      #define max_flash 0x10000
   ENDIF
   IFDEF __18F4620
      #include "p18f4620.inc"
IdTypePIC = 0x4F
      #define max_flash 0x10000
   ENDIF


and loaded the tinybld18F2620.HEX to controller then i tried to detect the hardware using tinybldWin.exe
which was successful and the message showed was

Code:
Connected to \\.\COM1 at 115200
  Searching for PIC ...
  Found:18F 2620/4620


Then i tried to load my application but following error came
Code:
Connected to \\.\COM1 at 115200
  HEX: 8 min old, INHX32,18Fcode+cfg, total=33844 bytes.
  Searching for PIC ...
  Found:18F 2620/4620
  Could not write
  ERROR!


I am also using hardware UART pin c6 and pin c7 for other purpose with baud rate of 9600.
Kindly suggest me a solution as i am stuck,

Thanks
_________________
sohail khan
sohailkhanonline



Joined: 06 Mar 2008
Posts: 35
Location: pakistan

View user's profile Send private message Visit poster's website Yahoo Messenger MSN Messenger

PostPosted: Fri May 16, 2008 6:57 am     Reply with quote
problem solved, I was using same UART for other application
Very Happy
_________________
sohail khan
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group