CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to CCS Technical Support
ICD-S40 PIC16F877A. Target could not detected

 
Post new topic   Reply to topic    CCS Forum Index -> CCS ICD / Mach X / Load-n-Go
View previous topic :: View next topic  
Author Message
Surati
Guest
ICD-S40 PIC16F877A. Target could not detected
PostPosted: Thu Mar 20, 2008 10:34 pm     Reply with quote
I just bought PIC16F877A development Kit. I couldn't run a test target of ICD Control Program. An error message Target could not detected appears. I run the hardware diagnostic, but I failed to read device ID. The error appears " The device ID is not a valid device id for the target chip". I have check cable connection, it's look properly connected. Anyone can help me to solve the problem since I'm new in programming embeded software.

Thanks .
PCM programmer



Joined: 06 Sep 2003
Posts: 21708

View user's profile Send private message

PostPosted: Thu Mar 20, 2008 10:46 pm     Reply with quote
Here is the ICD-S Reference Manual:
http://public.enst-bretagne.fr/~moga/ISI407/ICD-S%20User%20Manual.pdf

It says to check these things:
Quote:
Error: Could not detect target chip

- Verify target oscillator is working.
- Check cable from ICD to target.
- Make sure that the target chip is a supported PIC16 or PIC18

Did you have a crystal and load capacitors connected to the PIC ?
Do you have a 47K pull-up resistor on the MCLR pin of the PIC ?
foodwatch



Joined: 18 Apr 2006
Posts: 66

View user's profile Send private message Yahoo Messenger

PostPosted: Fri May 09, 2008 5:26 pm     Reply with quote
be sure your target is powered from its own supply. This error will occur if your pic is not powered.
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> CCS ICD / Mach X / Load-n-Go All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group