CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to CCS Technical Support
Warning: 12F683 development board RJ11 jack

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
jcsquire



Joined: 13 Nov 2007
Posts: 1

View user's profile Send private message

Warning: 12F683 development board RJ11 jack
PostPosted: Wed Nov 21, 2007 11:35 pm     Reply with quote
At least mine has an intermittent fault, and I bet someone else will be searching the forum because of the same symptoms: the ICD.exe application will say "target not found" and although it will have a good 5.0V VDD, it's VPP will measure 5V even during programming.

Simple fix: pry out the little wire connectors on the jack.

This is the type of weird and intermittent problem that is making history and communication the preferred majors among undergraduates today.

(No fault to CCS...this stuff just happens! Keep making those great little development boards!)
PCM programmer



Joined: 06 Sep 2003
Posts: 21708

View user's profile Send private message

PostPosted: Thu Nov 22, 2007 2:28 am     Reply with quote
It was reported a few years ago in this thread:
http://www.ccsinfo.com/forum/viewtopic.php?t=19258
(I remembered it was there).
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group