changing baudrate in #use rs232

ivanperino · Joined: 08 Jun 2006 Posts: 14

What should I do to change the baudrate on non-UART rs232 implementation?

I need to work in different speeds, 9600 and 38400 while microprocessor is running.

I have seen you can use setup_uart() but it only works over Hardware UART implementation.

Thank You in advance

Ttelmah · Guest

Declare multiple 'streams', with the required rates, and select the one you need.
The code is custom patched to give the required rate. Each #use RS232 statement generates the code for the specified rate (once used).

Best Wishes