Hello!
I have a big problem...
I have written a program for a PIC18F258 that consists in switch on some leds, but it only runs in debug mode... when I want to program the pic in normal mode, the pic doesn`t switch on the leds. The corresponding pins are floating, so sometimes the leds shine and sometimes donĀ“t...
What would be the problem? I check all the circuit and there aren`t any shorcut, i have changed the pic but it isn`t the problem...
Could the oscillator be the problem?
Thank you everybody and sorry about my english... I am spanish
ckielstra
Joined: 18 Mar 2004 Posts: 3680 Location: The Netherlands
Posted: Wed Jul 11, 2007 4:14 am
Which programmer are you using?
Which IDE are you using? (MPLAB or the CCS IDE?)
Guest
Posted: Wed Jul 18, 2007 5:05 pm
Hi
Had same problem, if using MPLAB and ICD 2 switch from debugger to progammer mode and all should work fine.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum