Problem with ICD U40 --> Target was not reset

bard · Guest

Hi Everyone

I am having one problem while using ICD U40.
Now i am using PIC16F877A with ICD U40.

During initialise ICD, the error Pop out as
" Target was not reset, check target oscillator and MCLR.
Somebody help me.

Guest · Posted: Tue Feb 06, 2007 7:22 pm

I am having the same problem with a 18f1220, but work OK if I use an ICD-S...

CCS Technical Support does not monitor this forum on a regular basis. Please do not post bug reports to this form. All bug reports should be emailed to [email protected]. Thank you.

frustrated EE · Guest

I have the same problem with mine

buneri · Guest

I was having the same problem with ICD U.
I had connected the low value resistor with MCLR(10k).
Now i have connected the 47k resistor and my problem is solved.

Guest · Posted: Tue Mar 13, 2007 10:57 am

The answer to that is some version of ICD software have problems with internal oscillator. You may have to go to an older version.