CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to CCS Technical Support
MPLAB 7.41 with PCB

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
dustooff



Joined: 05 May 2004
Posts: 3
Location: Toowoomba, Australia

View user's profile Send private message

MPLAB 7.41 with PCB
PostPosted: Tue Jul 25, 2006 11:46 pm     Reply with quote
Ok so I own a license for PCM, and have been faithfully using it under MPLAB, all good. so now I see that PCB is avail with 7.41, so I did the MPLAB upgrade but don't have access to PCB for 12bit devices, PCB is unpacked in the third party drivers area, and I have PCM installed in an upper level directory that MPLAB knows about in the executable link. Is it one or the other, or am I missing somthing?
AB
dustooff



Joined: 05 May 2004
Posts: 3
Location: Toowoomba, Australia

View user's profile Send private message

Fixed
PostPosted: Wed Jul 26, 2006 6:40 pm     Reply with quote
I worked it out, its all in the installation...
make sure they both (PCB & PCM) install in the same directory.
the main difference between them is in the DLL dir PCB == pcb.dll, PCM == pcm.dll.
now I can swap between 12bit and 14bit devices in MPLAB>>Configure>>Select device.
AB
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group