Strange error in printf?

[Robi77]

Hi!

Have a 18f252 with 20Mhz crystal and this code:

#include "error.h"
unsigned CHAR TxPacket[80];
unsigned CHAR RxPacket[80];
//unsigned CHAR HxPacket[80];
int u;


void main()
{

setup_adc_ports(NO_ANALOGS);
setup_adc(ADC_OFF);
setup_spi(FALSE);
setup_wdt(WDT_OFF);
setup_timer_0(RTCC_INTERNAL);
setup_timer_1(T1_DISABLED);
setup_timer_2(T2_DISABLED,0,1);
setup_timer_3(T3_DISABLED|T3_DIV_BY_1);
setup_oscillator(False);
while(1)
{
delay_ms(1000);
printf("hello %d",u);
u++;
}

}


#include <18F252.h>
#device adc=8

#FUSES NOWDT //No Watch Dog Timer
#FUSES WDT128 //Watch Dog Timer uses 1:128 Postscale
#FUSES HS //High speed Osc (> 4mhz)
#FUSES NOPROTECT //Code not protected from reading
#FUSES NOOSCSEN //Oscillator switching is disabled, main oscillator is source
#FUSES BROWNOUT //Reset when brownout detected
#FUSES BORV20 //Brownout reset at 2.0V
#FUSES PUT //Power Up Timer
#FUSES NOSTVREN //Stack full/underflow will not cause reset
#FUSES NODEBUG //No Debug mode for ICD
#FUSES LVP //Low Voltage Programming on B3(PIC16) or B5(PIC18)
#FUSES NOWRT //Program memory not write protected
#FUSES NOWRTD //Data EEPROM not write protected
#FUSES NOWRTB //Boot block not write protected
#FUSES NOWRTC //configuration not registers write protected
#FUSES NOCPD //No EE protection
#FUSES NOCPB //No Boot Block code protection
#FUSES NOEBTR //Memory not protected from table reads
#FUSES NOEBTRB //Boot block not protected from table reads

#use delay(clock=20000000)
#use rs232(baud=19200,parity=N,xmit=PIN_C6,rcv=PIN_C7,bits=9)

If i remark the second 80 byte array the program work perfectly. Every second writeout 'hello' and the number. BUT if i use the second array the program will go into crazy, write out this text in FULL speed:
llo -1<8hello -1<8hello -1<8hello -1<8hello -1<8hello -1<8hello -1<8hello -1<8hello -1<8hello -1<8hello -1<8hello -1<8hello -1<8hello -1<8hello -1<8hello -1<8hello -1<8hello -1<8hello -1<8hello -1<8

Anybody know why?
Thanks

[Robi77]

I tried out with 3.245, 3.242, 3.109

[PCM programmer]

Is that the entire program that causes the problem or is there more
code that you didn't post ?

It's possible that your code (code that's not posted) is writing past
the end of one of your arrays, and is clobbering some internal variables
used by the compiler. If you did this, it could cause the program to
go berzerk as you are seeing.



Other problems:

You have this fuse: