Software uart2 - Cant call function

[burnsy]

Problem 2

After invoking a software uart with the #use statement, I can use the putc() function to pass a char to a seriaL printer. However, if I call a function with a putc() in it, it doesn't work?

eg

myputc('A');

void
myputc(char x)
{
putc(x);

}

This doesn't work, but a normal putc('A'); DOES work.

Looks like a compiler problem, as this works on my old 16F processors. Pulling my hair out.. need help ;) Thanks everyone
_________________
This is the last code change until its ready....

[SherpaDoug]

Is there any chance you are running out of stack space? Look at the calling tree vs the stack depth for your processor.
_________________
The search for better is endless. Instead simply find very good and get the job done.

[burnsy]

Stack space seems to be ok. List files says level 5 + 2 for interrupts. The call that doesn't seem to work is only 3 function calls into the stack, I think?

If you saw my other post RE comms problems, it would seem I have a compiler problem, or, the whole thing setup wrong.

regards
_________________
This is the last code change until its ready....

[burnsy]

Hi everyone,

turned out to be the compiler. 3.209 works perfectly
_________________
This is the last code change until its ready....