F628 port A0 and A1 not functioning as inputs

[oscar]

Hello everyone,
I am using the F628 and am having a hard time reading A0 and A1.
I know there's analog comparators but I have turned those off.
I set the trisA to 0x03 (A0 and A1 as inputs) but yet I can't read them correctly.

This is part of the code:
[b]setup_counters(RTCC_INTERNAL,WDT_1152MS); //Set watchdog to reset uC after 1152ms
setup_timer_1(T1_DISABLED); //Disable Timer 1
setup_timer_2(T2_DISABLED,0,1); //Disable Timer 2
setup_comparator(FALSE); //Disable comparator
setup_vref(FALSE); //Disable comparator voltage reference

// Set Port A I/O direction register to 0000 0011 ///////////
set_tris_a(0x03); //Pins A0 and A1 are inputs, rest are outputs[b]

and then I try to read A1 (there's a high on this pin)
if(!input(A0))
{do something}

this piece of code should execute if A0 = 0 but it doesn't.
What's going on? What am I doing wrong?
Please advise,
OScar

[Oscar]

This is a correction to the first message:

"and then I try to read A1 (there's a high on this pin)
if(!input(A0))
{do something} "

should read:
and then I try to read A1 (there's a high on this pin)
if(!input(A1))
{do something}

Oscar

[Ttelmah]

[Oscar]

[Ttelmah]