ICEPIC & CCS

berler_d · Joined: 13 Apr 2004 Posts: 8

Hi All,

Does CCS supports the ICEPIC ?
I tested the .cod of the latest version and found that it dosent work.
(In the past it worked)

What can be done about it ?

Neutone · Joined: 08 Sep 2003 Posts: 839 Location: Houston

Did you try both versions of the .cod that are supported?

Guest · Posted: Wed Jun 16, 2004 8:51 am

Yes, I tryed both and it didnt work.
(In the past the .cod worked fine with ICEPIC)

Do you have any Idia how to solve this problem ..

Neutone · Joined: 08 Sep 2003 Posts: 839 Location: Houston

Do you have old code that continues to work as expected to verify that the ICEPIC works?

berler_d · Joined: 13 Apr 2004 Posts: 8

Hi Nutone,

I started to check it and found these results:

The ICEPIC works fine with old CCS compiler, you can debug and look at the code.

In the new CCS version it seems that the code is loaded and run , but you cant debug it because you cant see the LST or the source code.

you can only see the disassembler (and it dosent help).

prwatCCS · Joined: 10 Dec 2003 Posts: 70 Location: West Sussex, UK

PLEASE tell us whihc versions of everything you are using.

CCS old and new, Icepic .. without that its hard to relate to anyone else's experience and/or setup.
_________________
Peter Willis
Development Director
Howard Eaton Lighting Ltd UK

berler_d · Joined: 13 Apr 2004 Posts: 8

Hi,
The old verson is: 2.454 (cod with no .)
The new version is: 8.02

Using ICEPIC2 with newest software 2.13

Please note that I cant see the code tracking or list, just the disassembler window.

berler_d · Joined: 13 Apr 2004 Posts: 8

anyone has an answer ???

berler_d · Joined: 13 Apr 2004 Posts: 8

anyone has an answer ???