CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to CCS Technical Support
166 key keyboard

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
jb miller



Joined: 17 Dec 2003
Posts: 1

View user's profile Send private message

166 key keyboard
PostPosted: Wed Dec 17, 2003 11:55 am     Reply with quote
Hello.Need a little help getting a 166 key keyboard going.Am using a 16F877 and figure a 13 by 13 matrix is the fewest pins. How do I use the union or structure commands to allow different pins of differnt ports to become the rows and columns? I've done 8by8 matix before,this however is a challenge.All help is appreciated. I tried old posts but nothing seemed to be what I need.
Jay
PCM programmer



Joined: 06 Sep 2003
Posts: 21708

View user's profile Send private message

PostPosted: Wed Dec 17, 2003 12:23 pm     Reply with quote
See the post by Mark in this thread, where he expands the CCS
lcd_pin_map structure to use more than one port.
http://www.ccsinfo.com/forum/viewtopic.php?t=17323
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group