CCS :: View topic - Working code for the exercise B in to USB Master book.

FAQ

Forum Help

Official CCS Support

Profile Log in to check your private messages Log in

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to CCS Technical Support

Working code for the exercise B in to USB Master book.

CCS Forum Index -> Code Library

View previous topic :: View next topic

Author

Message

Mark A Carter

Joined: 28 Aug 2011
Posts: 5
Location: Vail Arizona USA

Working code for the exercise B in to USB Master book.

Posted: Wed Nov 06, 2013 11:54 pm

Dear programers.
This blinks the three LEDs contained in the PIC18F67J10 trainer PCB.
This is a working example to do the question B under the FURTHER STUDY section.

Thank you.

Mark A Carter Smile

Code:

#include <18F67J10.h>
#device ICD=TRUE
#fuses HS,NOWDT
#use delay (clock=10000000)

#define GREEN_LED PIN_D5
#define YELLOW_LED PIN_D1
#define RED_LED PIN_D0
#define delay_in_seconds delay_seconds

void delay_seconds(int n) {
for (;n!=0;n--) {
delay_ms (1000);
}
}

void main () {
while (TRUE) {
output_low (GREEN_LED);
delay_in_seconds (5);
output_high (GREEN_LED);
delay_in_seconds (5);
output_low (YELLOW_LED);
delay_in_seconds (1);
output_high (YELLOW_LED);
delay_in_seconds (1);
output_low (RED_LED);
delay_in_seconds (5);
output_high (RED_LED);
delay_in_seconds (5);
}
}

_________________
Mark A Carter

KD7PHW

Display posts from previous:

	CCS Forum Index -> Code Library	All times are GMT - 6 Hours
Page 1 of 1

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum