Question

bkamen · Posted: Wed Jan 05, 2011 10:57 pm

Don't forget to change the topic of your post to something other than, "Question" -- it's not useful for others searching out posts that might be of a similar issue.

Maybe something like:

"SHT10 Digital to Analog on 18F452" might be a good one.

Cheers,

-Ben
_________________
Dazed and confused? I don't think so. Just "plain lost" will do. :D

alireza121 · Joined: 09 Dec 2010 Posts: 9

Hello SherpaDoug

Thanks a lot for your reply.

Actually the input of a fuzzy system is analog signal not numbers,rather than,the output of a fuzzy system is numbers and not analog signal.

Cheers,

bkamen · Posted: Thu Jan 06, 2011 11:55 am

The original post -- not this one.

you need to change the first post of the thread.

Thanks,

-Ben
_________________
Dazed and confused? I don't think so. Just "plain lost" will do. :D

alireza121 · Joined: 09 Dec 2010 Posts: 9

Hello SherpaDoug

Thanks a lot for your reply.

Actually the input of a fuzzy system is analog signal not numbers,rather than,the output of a fuzzy system is numbers and not analog signal.

Cheers,

bkamen · Posted: Thu Jan 06, 2011 12:14 pm

Not quite yet.

You want to EDIT your first post on this thread... and *change* the subject line.

So Click back on Page one, scroll to the top where you initial post is and EDIT the post.

From there, you can change the subject line.

You can verify this by looking at the list of topics in the "General CCS C Discussion" list.

Cheers,

-Ben
_________________
Dazed and confused? I don't think so. Just "plain lost" will do. :D