CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to CCS Technical Support
external interrupt on Pin E3 pic16f887

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
William



Joined: 11 Sep 2010
Posts: 8

View user's profile Send private message

external interrupt on Pin E3 pic16f887
PostPosted: Sun Sep 12, 2010 1:43 am     Reply with quote
Hi i was wondering how i could get an external interrupt working on pin E3 or any of the E port pins, i am using all of port B already. thanks
Ttelmah



Joined: 11 Mar 2010
Posts: 19496

View user's profile Send private message

PostPosted: Sun Sep 12, 2010 3:49 am     Reply with quote
No.
Read the data sheet.
Look at Table3. The 'interrupt' column, tells you all.

You can generate an interrupt 'trick', on the CCP input pins (C1/C2), since in 'capture' mode, these will trigger a CCP interrupt, when the programmed edge is seen. Might be a solution.

Best Wishes
William



Joined: 11 Sep 2010
Posts: 8

View user's profile Send private message

PostPosted: Sun Sep 12, 2010 4:22 am     Reply with quote
Thanks I'll have to do a work around.
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group