I have a button and led circuit. But it didn't work properly.
I set up the circuit on the breadboard but when I push the button the led didn't work. When I take off the button's + cable, led works. What it must be? It's interesting my circuit works in Proteus with no problem.
TABLE 6-2: CAPACITOR SELECTION
FOR CRYSTAL OSCILLATOR
It shows the oscillator fuse setting for some typical crystal frequencies.
Look at your crystal frequency, and find the correct fuse in the table.
Then edit your #fuses statement and fix the problem.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum