How to progam pic without erasing EEPROM with ICD

[csanders]

I am having 2 issues with an ICD-S40 programmer

Problem 1: When debugging in PCWH when the debugger is first enabled, is it possible to keep the ICD-S40 from overwriting stored values in the EEPROM on the PIC?

Problem 2: When programming the PIC from the ICD interface program (version: 2.72) I uncheck 'Data EEPROM' option under Erase & Burn in the Advanced section of the program. How can I get the ICD to retain these values? If I close the ICD application & start it again this setting is lost.

In an older version 2.51 this setting was retained. Why not in version 2.72?

Any one else experience this problem?

Thanks

[dgi]

I'm having the same problem today. I set the loader program to not erase the data EEPROM and it erases it anyway.

I had had this problem with earlier versions of the ICD program, and I never resolved the issue. But for the past 2 weeks I have been using version 4.009 of ccsload, and it was very good at not erasing the EEPROM when I didn't want it to. I never saw it erase the data without my permission.

But when I updated to version 4.010 today, it is back to forgetting my settings, and randomly erasing the data eeprom. Does anyone else have this problem or a solution?