TCP/IP Stack

biomed12 · Joined: 05 Feb 2016 Posts: 33

Hello Dear Members,

I have been working with ccs about 1 year. I have used many features of MCUs by using CCS. Nowadays, i need to use TCP/IP stack to connect my MCU using devices to the internet. So that, i used the CCS project wizard to create project and when i tried to run project on Proteus, there was no error. But when i enter my MCUs IP (which is working on proteus) to my browser address line, there is no reaction. I thought maybe i had done something that is wrong and so i downloaded some projects and just run it. There was no change. Are there any issue or missing software/tool to see the HTML page on browser? My simulation is not working. I want to do this exactly:

https://www.youtube.com/watch?v=bCyCvZAf--k (1. video)
https://www.youtube.com/watch?v=Zk3FBpyZzdE (2. video)

notice: i know videos very bad.

Thanks.

bkamen · Posted: Mon Aug 15, 2016 9:41 pm

Did you read the sticky note at the top of the forum about "no more proteus questions"?

-Ben
_________________
Dazed and confused? I don't think so. Just "plain lost" will do. :D

temtronic · Posted: Tue Aug 16, 2016 5:56 am

I'm 'dazed and confused' that posters keep thinking that Proteus IS a working program. It is SO full of errors and faulty DRCs I'm amazed it actually 'works' at all.
Come to think of it , I've never seen a Proteus schematic posted here that WOULD work in the Real World.

Jay

newguy · Joined: 24 Jun 2004 Posts: 1907

Proteus is to successful co-simulation as ISIS is to society at large.