CCS :: View topic - Sleep mode on a 18F87J11

FAQ

Forum Help

Official CCS Support

Profile Log in to check your private messages Log in

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to CCS Technical Support

Sleep mode on a 18F87J11

CCS Forum Index -> General CCS C Discussion

View previous topic :: View next topic

Author

Message

mobrien99

Joined: 15 Apr 2013
Posts: 3
Location: Penn Yan, NY

Sleep mode on a 18F87J11

Posted: Tue Jul 23, 2013 9:43 am

I would like to extend battery life by sleeping or idling the processor.
I have a 100 ms interrupt routine based on timer1 and an SPI interrupt that comes alive when a packet is received from my SiLabs transceiver tied to pin B0.

Code:

// define for high to low transitions
ext_int_edge(0,H_TO_L);
enable_interrupts(int_ext); // enable Pin B0 for si4455 interrupts

What is the best way to set up the sleep mode? Will the interrupt overflow from the timer1 interrupt routine wake me up and if so would get_timer1 return the utilized ticks to get awake again? If an SPI interrupt would have occurred between the 100ms slices, will I miss that if I am sleeping?

Thanks

Mike O'Brien

Display posts from previous:

	CCS Forum Index -> General CCS C Discussion	All times are GMT - 6 Hours
Page 1 of 1

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum