CCS :: View topic - PIC24HJ128Gp504 SPI DMA Problem

FAQ

Forum Help

Official CCS Support

Profile Log in to check your private messages Log in

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to CCS Technical Support

PIC24HJ128Gp504 SPI DMA Problem

CCS Forum Index -> General CCS C Discussion

View previous topic :: View next topic

Author

Message

Thorsten

Joined: 08 Oct 2012
Posts: 1

PIC24HJ128Gp504 SPI DMA Problem

Posted: Mon Oct 08, 2012 8:02 am

Hi @ all,

I am trying the first time the DMA Controller in the PIC24. I just want to transmit one Array of Data out to the SPI2 Hardware.

This "Code" I use:

Code:

setup_dma(0, DMA_OUT_SPI2, DMA_byte );
dma_start(0, DMA_CONTINOUS, &pixel5[0] );

My array look so:

Code:

#BANK_DMA
unsigned int8 pixel5[550] = {};

So what I get out from that:

If I didn't do a normal "spi_write2" in the Main loop, I didn't get anything out from SPI. But if I send i.e. spi_write2(0x01); then the DMA send out 2 additional bytes. But why not 550 like the Arraysize ? I checked already the Listing, and it seems there is everything ok. Did I have to activate some Interrupts for the SPI? I hope someone could help.

Best Regards

Thorsten

Display posts from previous:

	CCS Forum Index -> General CCS C Discussion	All times are GMT - 6 Hours
Page 1 of 1

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum