ICD-U40 debug - gets/printf

[schmez]

I am trying to debug using the ICD-U40 on a PIC16F690 - all works in debugger but the "Monitor" section does not seem to work. I have the "#use RS232(DEBUGGER)" set and nothing shows in the monitor and it does not allow me to send characters as well - I cannot find any good documentation on using the debugger in the PCW.
Thanks.

[schmez]

Here is a sample code I am testing - it will not show Hello World in the monitor window in the PCW software debugger:

#include <16F690.h>
#device adc=16

#FUSES NOWDT //No Watch Dog Timer
#FUSES HS //High speed Osc (> 4mhz for PCM/PCH) (>10mhz for PCD)
#FUSES NOBROWNOUT //No brownout reset

#use delay(clock=20000000)

#include <stdio.h>

#include <string.h>
#use rs232(DEBUGGER)

main()
{
printf("Hello World \n\r");

while(1);
}

[schmez]

Have to connect wire from pin 6 of J2 on header to a xmit pin on emulator.

For example:
#use RS232(DEBUGGER, xmit=PIN_B7, RCV=PIN_B7)

Pin B7 on the header emulator was connected to pin 6 of J2 (the RJ45 plug for the debugger).