CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to CCS Technical Support
Which ICD/PICkit tool should be used with 16F687 for debug

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
kongfu1



Joined: 26 Apr 2010
Posts: 56

View user's profile Send private message

Which ICD/PICkit tool should be used with 16F687 for debug
PostPosted: Wed May 11, 2011 8:52 pm     Reply with quote
Hi,

Just start to work new project with PIC16F687. Development tools are CCS compiler and MPLAB IDE.

To be able to debug the code with break point and step over/into functions, a few questions:

1. Is PICKit2 or PICKit3 works with CCS for ICSP debug?
2. If PICKit2 and 3 does not working with CCS, which ICD shall be used?
3. With ICD device, any special header board (such as 16F690 header board) must be used or not?

Thanks,
Howard
PCM programmer



Joined: 06 Sep 2003
Posts: 21708

View user's profile Send private message

PostPosted: Thu May 12, 2011 1:35 pm     Reply with quote
Quote:

1. Is PICKit2 or PICKit3 works with CCS for ICSP debug?
2. If PICKit2 and 3 does not working with CCS, which ICD shall be used?

Read the CCS faq on the topic:
http://www.ccsinfo.com/faq.php?page=icd2_real_ice
I think that CCS only supports debugging with ICD2 and ICD3, and not
programming-only. Below in this thread, one person protests over and
over that it should work as a programmer. I don't work for CCS.
How do I know ? Email CCS about it.
http://www.ccsinfo.com/forum/viewtopic.php?t=44898


Quote:

3. With ICD device, any special header board (such as 16F690 header board) must be used or not?

Go to the Microchip ICD3 page. Download the Header Specification.
Search it for "687". Notice the part number of the required header.
http://www.microchip.com/stellent/idcplg?IdcService=SS_GET_PAGE&nodeId=1406&dDocName=en537580
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group