CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to CCS Technical Support
CCS ICD-U40 failed to program

 
Post new topic   Reply to topic    CCS Forum Index -> CCS ICD / Mach X / Load-n-Go
View previous topic :: View next topic  
Author Message
akokyaw



Joined: 11 Feb 2005
Posts: 24

View user's profile Send private message

CCS ICD-U40 failed to program
PostPosted: Fri Oct 22, 2010 2:06 am     Reply with quote
Hi dude,
I've a CCS ICD-U40 (firmware 2.85) and use ccsload program to flash 18F4680, and there is an error about configuration bits unmatched. I use Microchip ICD2 and it can flash the chip perfectly. Can anyone help me to solve the problem?

regards,
pak
ching



Joined: 01 Nov 2010
Posts: 1

View user's profile Send private message

PostPosted: Mon Nov 01, 2010 4:54 pm     Reply with quote
hi .
I had a similar problem. I believe when ccsload read the hex file, sometimes it misses the configuration parts, so the program still uses the default configuration data. I would suggest you go to File and and go to configuration /ID to change the configuration bits manually. Click save. Then try to write to chip again. Hopefully, it solves the problem.

Ching
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> CCS ICD / Mach X / Load-n-Go All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group