CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to CCS Technical Support
PIC24HJ128GP202 + FUSES + setup_oscillator

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
pasini



Joined: 12 Dec 2005
Posts: 50
Location: Curitiba - Brazil

View user's profile Send private message Send e-mail

PIC24HJ128GP202 + FUSES + setup_oscillator
PostPosted: Mon Feb 02, 2009 8:21 am     Reply with quote
Hi,
I have a project with PIC24HJ128GP202 and I have some doubts about FUSES and setup_oscillator.

I want the PIC to run at 40MIPS from internal oscillator and datasheet says that the basic frequency is 7.37MHz. I can tune the oscillator up and down and use the PLL.

But actually how do I set fuses ( is it INT_RC ? ), where do I set the PLL and what do I put in setup_oscillator and #use (CLOCK=40MHz) ?
Do I really need setup_oscillator ?

Thanks for any help,
Pasini
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group