DSPIC30F6010A and #FUSE

[Honken]

I am trying to get correct FUSE for the oscillator on a DSPIC30F6010A.

I want to run HS on primary osc.

But when I use the following fuse

#FUSES LP //Low power osc <200> 4mhz)
#FUSES HS
#FUSES NOCKSFSM //Clock Switching is disabled, fail Safe clock monitor is disabled

The CCS compiler turns on the low power 32khz osc option.

I also tried to coment out the first line, but the MPLAB then tells me that the config words are wrong.

Any ideas?

[Guest_7068]

Try using the 'PR' fuse. CCS says that this fuse is required as long as the
primary oscillator is used. The FRC does not need this fuse.

[Honken]

That helped!

Thanks