CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to CCS Technical Support
Setting Channel No in Ember Zigbee

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
hayee



Joined: 05 Sep 2007
Posts: 252

View user's profile Send private message

Setting Channel No in Ember Zigbee
PostPosted: Sat Aug 22, 2009 12:40 am     Reply with quote
Hi,
I want to set channel Id through DIP switch.There are 16 channel available in Ember Zigbee. I will use four pins of microcontroller and read the pins and according to the pin's status I will select the desired channel.
But the problem is that Channel is selected at the top of the program by using this command:
Code:
#define APP_CHANNEL 0x0B

and then em260.h is loaded to confirm this setting.

My question is where do I define my particular settings for channel selection?
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group