CCS getting started with pic 12f629

[Sebastian20000]

Hi,
I´m a rookie in using pic controllers and even the simplest program
doesn´t work. For testing i only want to set high the Pins A0, A1 and A2,
but when I connect the pic to the demo board nothing happens.
(I am using the pic 12F629)
I hope you can give me a small start hint:

((.c data:))


#include "C:\Dokumente und Einstellungen\Sebastian.SEPPEL\Eigene Dateien\pic\test2.h"

void main()
{
setup_timer_0(RTCC_INTERNAL|RTCC_DIV_1);
setup_timer_1(T1_DISABLED);
setup_comparator(NC_NC);
setup_vref(FALSE);

OUTPUT_HIGH(PIN_A0);
OUTPUT_HIGH(PIN_A1);
OUTPUT_HIGH(PIN_A2);
}



((.h data))

#include <12F629.h>

#FUSES NOWDT //No Watch Dog Timer
#FUSES LP //Low power osc < 200 khz
#FUSES NOCPD //No EE protection
#FUSES NOPROTECT //Code not protected from reading
#FUSES NOMCLR //Master Clear pin used for I/O
#FUSES NOPUT //No Power Up Timer
#FUSES NOBROWNOUT //No brownout reset
#FUSES BANDGAP_HIGH
#use delay(clock=4000000)

((standard 12F629.h))

Thank you very much!

[PCM programmer]

[Sebastian20000]

you mean instead of :
#FUSES LP //Low power osc < 200 khz
=>
#fuses INTRC_IO

can you explain what is the effect of this fuse?
I don´t find it in my manual...


quote: Thank you veryy much :-) it works

[PCM programmer]

See this thread for an explanation:
http://www.ccsinfo.com/forum/viewtopic.php?t=31698

[Sebastian20000]

ok, i got it.
stupid fault