CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to CCS Technical Support
PIC16F696 Emulator Board

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
Trent____
Guest
PIC16F696 Emulator Board
PostPosted: Tue Jul 24, 2007 5:22 am     Reply with quote
Hi,

I have a Microchip emulator board which has PIC16F636 and the extra IC for the AFE. This device is made to allow in-circuit debugging for the PIC16F639.

I have an issue with the CCS debugger. It is only executing about the first 100 lines then stops. The debugger continues to run. When set a break point after this point the debugger does not break. I have varied the type of code after this point and the result is the same. In the ASM list there is code and is seems resonable.


Is there something I am missing here ?

I am not sure what other information to offer, I am using the current compiler and IDE from CCS as of this morning. 24/7/07.

Any comments would be a big help.

t.
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group