CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to CCS Technical Support
simulate int_rb in mplab

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
qbeexx



Joined: 19 Jul 2007
Posts: 2

View user's profile Send private message

simulate int_rb in mplab
PostPosted: Mon Jul 23, 2007 1:40 am     Reply with quote
I would like to use port-b as interupt on change.
I run the example C:\Program Files\PICC\Examples\EX_PBUTT.C that given by ccs.
I put a breakpoint inside the #int_rb, and I tried the "fire" to tongle pin b4, b5, b6 and b7 at Stimulus.
But it will never stop at #in_rb when I "fire" on pin b4 to b7 it during the run time.

Please correct my steps to simulate the #int_rb.
Thanks.
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group