CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to CCS Technical Support
USB, PIC18F2550, 12Mhz Crystal

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
PeterDove



Joined: 06 Jan 2007
Posts: 12

View user's profile Send private message

USB, PIC18F2550, 12Mhz Crystal
PostPosted: Sat Jan 06, 2007 11:30 am     Reply with quote
Hi,

I am attempting to run the USB example, adjusting it for the PIC18F2550 and I would like to know if someone could tell me the setup ( or if it is possible ) to get the chip to run at 48Mhz from the 12Mhz crystal.

Thanks

Peter
PCM programmer



Joined: 06 Sep 2003
Posts: 21708

View user's profile Send private message

PostPosted: Sat Jan 06, 2007 1:31 pm     Reply with quote
Try the setups shown near the end of this thread. They may help.
http://www.ccsinfo.com/forum/viewtopic.php?t=29103&highlight=usb+oscillator+setup
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group