 |
 |
| View previous topic :: View next topic |
| Author |
Message |
pikman
Joined: 20 Dec 2004
Posts: 4
|
| PROBLEM ICDS-40 PIC18F452 AT 40MHZ |
 Posted: Wed Nov 22, 2006 4:54 pm |
 |
|
I'm using an ICDS-40, when I try run at 40 mhz this show 10 mhz speed, but if if I interrupt power source and conect again, when devive is reconect whit ICD it makes at 40 mhz.
If recompile and reload target firmware, returns another time to be connected to 10 mhz, I must disconnect the power again and to reconnect the ICD from the soft, has somebody this problem?, can you help me.
icd control program version is rev 2.51 and firmware rev. 1.39
cheers
ARIEL |
|
 |
PCM programmer
Joined: 06 Sep 2003
Posts: 21708
|
|
| Posted: Wed Nov 22, 2006 5:15 pm |
|
|
| Quote: |
If recompile and reload target firmware, returns another time to
be connected to 10 mhz, I must disconnect the power again and to
reconnect the ICD from the soft, has somebody this problem ?
|
This is normal. After programming the PLL oscillator mode in the PIC,
you must "cycle the power" (turn it off and on) to enable the PLL mode.
The ICD has a PIC inside it. So it also has this requirement. |
|
|
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
|
FAQ 
Search
Register
Profile 
Log in to check your private messages 
Log in
