CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to CCS Technical Support
PWM problem.

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
guest216
Guest
PWM problem.
PostPosted: Fri Nov 17, 2006 11:03 am     Reply with quote
Hi All!

I'm using the PIC18F44J10 and it's ECCP for a motor driver.
I need to use the other PWM channel (CCP2) for other part of the board
but, I just can't 'get' it to work, the pin direction is good and the compiler
show no errors.
Any ideas?
PCM programmer



Joined: 06 Sep 2003
Posts: 21708

View user's profile Send private message

PostPosted: Fri Nov 17, 2006 5:55 pm     Reply with quote
Post a very short test program, in which you setup both CCP1 and CCP2
for PWM. Also post your compiler version.
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group