CCS :: View topic - How to make chip run without ICD

CCS C Software and Maintenance Offers

FAQ

Official CCS Support

Profile Log in to check your private messages Log in

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to CCS Technical Support

How to make chip run without ICD

CCS Forum Index -> CCS ICD / Mach X / Load-n-Go

View previous topic :: View next topic

Author

Message

swb1

Joined: 13 May 2006
Posts: 1
Location: LONG ISLAND

How to make chip run without ICD
Posted: Sat May 13, 2006 7:47 am

After debugging how do you download the program so that the chip will start and run without the ICD connected? I am looking for the proper #device setting. Thank You

Einstein
Guest


Posted: Tue May 30, 2006 6:25 am

After debugging, the device had just been programmed by the ICD, so it's ok and if your code is tested, the PIC is programmed

PCM programmer

Joined: 06 Sep 2003
Posts: 21708

Posted: Tue May 30, 2006 2:46 pm

Reply with quote

Quote:

After debugging how do you download the program so that the
chip will start and run without the ICD connected?
I am looking for the proper #device setting

Here are several threads on this topic:
http://www.ccsinfo.com/forum/viewtopic.php?t=23937
http://www.ccsinfo.com/forum/viewtopic.php?t=23096
http://www.ccsinfo.com/forum/viewtopic.php?t=21380
http://www.ccsinfo.com/forum/viewtopic.php?t=18224
http://www.ccsinfo.com/forum/viewtopic.php?t=23719

Display posts from previous:

	CCS Forum Index -> CCS ICD / Mach X / Load-n-Go	All times are GMT - 6 Hours
Page 1 of 1

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum

Powered by phpBB © 2001, 2005 phpBB Group