CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to CCS Technical Support
Problem connecting using ICD-U40

 
Post new topic   Reply to topic    CCS Forum Index -> CCS ICD / Mach X / Load-n-Go
View previous topic :: View next topic  
Author Message
bsb84
Guest
Problem connecting using ICD-U40
PostPosted: Sun Apr 30, 2006 12:52 pm     Reply with quote
Hi All!

I'm using CCS-PCWH v3.235 and ICD-U40 to write and debbug my PIC18F4550 board.

I am able to compile and the run the program using the debbug mode in the compiler.

But when i try to burn the code independently using the icd.exe i am unable to connect and detect the target chip.

The icd-u40 shows COM3 as the only port, to which i am unable to connect. I dont understand souldn't it detect a USB port instead of COM port. Is it a problem with the windowsXP that i dont have any access to the ports?

Any suggestion to get the program working without using the debugger mode?

Thanks.
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> CCS ICD / Mach X / Load-n-Go All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group