PIC18F2410 write_eeprom write_program_eeprom Compile Problem

[hoppenfeld]

Hi,

We recently upgraded a PIC16F88 to a PIC18F2410. For the most part the upgrade has gone well except for writing to the PIC EEPROM. Previously we used the write_eeprom however this no longer compiles. We then tried the write_program_eeprom and write_program_memory functions with the appropriate parameters but get the same compile error:
Undefined identifier write_eeprom
Undefined identifier write_program_eeprom
Undefined identifier write_program_memory

On the other side the switch from read_eeprom to read_program_eeprom compiles with no problems.

Any insight would be greatly appreciated.

Thank you,

Robert

[PCM programmer]

According to the 18F2410 data sheet:

1. There is no mention of Data EEPROM in this PIC.

2. This PIC can't write to its program memory.
From the data sheet:

[hoppenfeld]

You should be able to write to flash memory using the write_program_memory command. Correct?

[PCM programmer]

From the 18F2410 data sheet:

[hoppenfeld]

Thanks. We are replacing the part with a PIC18F2420.