hi, all, I have a question about :18F452 Enhanced PWM mode setup in CCS
is there any built-in function to setup Enhanced PWM mode with two PWM signal output for push pull application? thanks a lot
ttelmah Guest
Re: 18F452 Enhanced PWM mode setup in CCS
Posted: Sat Jun 19, 2004 2:33 am
gunking88 wrote:
hi, all, I have a question about :18F452 Enhanced PWM mode setup in CCS
is there any built-in function to setup Enhanced PWM mode with two PWM signal output for push pull application? thanks a lot
Er.
The 18F452, only has the CCP module, not the ECCP module. Hence no support for push-pull operation. Check the chip's data sheet.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum