ICD Work for Debugging but not normal burning

[[email protected]]

My ICD works incredibly well for source level debugging. I absolutely love it. But when I try to flash the PIC with a normal program with debugging turned off, it (my application) won't run. I can flash using the ICD2 and the exact same .HEX file using MPLAB and it works right.

Any clues?

Thanks,
Kory

[Darren Rook]

What do you mean won't run?

Are you using PCW or the stand-alone ICD program to burn your chip?

[[email protected]]

By "won't run", I mean it doesn't execute my code, as far as I can tell. The PIC is executing something else, but not my code. Maybe its not executing anything -- I can't tell. It there is a way to tell, I'd like to know as I am new to the PIC chips.

I've tried programming both ways: from inside PCW or using ICD stand alone. Again, the same hex time programmed using the ICD2 & MAPLABS works.

Thanks,
Kory
[/quote]