CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to CCS Technical Support
Multi-processor mode RS-485

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
Francesco



Joined: 19 Feb 2004
Posts: 14

View user's profile Send private message

Multi-processor mode RS-485
PostPosted: Thu Feb 19, 2004 6:35 am     Reply with quote
I`am sorry about my bad Englisch, but i hope anyone can help me.
I want use PIC 18F252 and I want use a multi processor communication, using 9 bit for addess detection in hardware mode.
Can I Crying or Very sad set the register "TXSTA" "RCSTA" and baud rate ?
Can I use interrupt?
PCM programmer



Joined: 06 Sep 2003
Posts: 21708

View user's profile Send private message

PostPosted: Thu Feb 19, 2004 6:29 pm     Reply with quote
There is a sample RS485 network project at the bottom of this page.
It has source code and a schematic, and it's for CCS.
http://web.ukonline.co.uk/j.winpenny/
Franz
Guest
Multi processor mode
PostPosted: Fri Feb 20, 2004 7:26 am     Reply with quote
PCM programmer wrote:
There is a sample RS485 network project at the bottom of this page.
It has source code and a schematic, and it's for CCS.
http://web.ukonline.co.uk/j.winpenny/


Surprised OK! Thanks very much

BYE! Smile
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group