CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to CCS Technical Support

Search found 4 matches
CCS Forum Index
Author Message
  Topic: Could not read RAM: No responce from the ICD Data in buffer:
[email protected]

Replies: 6
Views: 21782

PostForum: General CCS C Discussion   Posted: Wed Dec 24, 2003 8:08 pm   Subject: CCS IDE Rules
Yes I did disable the LVPM.

I have also unplugged everything which could be damaged by the 5VDC and I still get the same error when I select the RAM debug list

I am working with the CCS ICD-U40 ...
  Topic: Could not read RAM: No responce from the ICD Data in buffer:
[email protected]

Replies: 6
Views: 21782

PostForum: General CCS C Discussion   Posted: Wed Dec 24, 2003 7:26 pm   Subject: Not using the MPLAB
I am using the CCS ICD-U40 for development, I do have a Microchip ICD2 but I was never able to get it to function on any hardware with XP.

I would like to stay with the CCS ICD-U40.

I am also us ...
  Topic: Could not read RAM: No responce from the ICD Data in buffer:
[email protected]

Replies: 6
Views: 21782

PostForum: General CCS C Discussion   Posted: Wed Dec 24, 2003 4:28 pm   Subject: Not a demo board
The other components in the embedded circuit all run at 3.3VDC and if I were to raise the VCC to 5.0VDC it would blow some of them.

I will try by unsodering them first.
It is a lot of work but it ...
  Topic: Could not read RAM: No responce from the ICD Data in buffer:
[email protected]

Replies: 6
Views: 21782

PostForum: General CCS C Discussion   Posted: Tue Dec 23, 2003 9:36 pm   Subject: Could not read RAM: No responce from the ICD Data in buffer:

During Debug I can not read the RAM or ROM Values but everything else I looked at worked fine .

The single step is rather slow.

I am only using a 47K ohm resistor pulling up the /MCLR pin and ...
 
Page 1 of 1
All times are GMT - 6 Hours
Jump to:  


Powered by phpBB © 2001, 2005 phpBB Group