Search found 64 matches

http://www.ftpmicro.com/index_en.html

english link

it's free
on that site you can find all code to use ftp stack.

try this device. it's opensource project.

http://www.ftpmicro.com/

It's not address problem. Any transimtter has it's own address. and receiver works only with its own address. but i need 2 or more couples working at same time.

sharing the same frequency.

Hi

I'm programming a remote relay controller using PIC.

Pic sends serial (rs232) data trough wireless 433MHZ or 868MHZ.

Transmitter sends some code bytes and receiver gets on serial receiv ...

I made some experiments. I found out it's a pic problem.
I swapped pic between an old device and a new one and the not working new one begun working nice while the old one didn't work as well.
then ...

HI,

I found out a curious problem yesterday and i still can't undertand it.
I programmed a transmitter and it's radioreceiver using pic16f88. I transmit data from RS232 Pin and i read bata in RS23 ...

NoWAY, I'm giving up.

with your code it doesn't work. PIN be can be controlled only forcing SW UART. but unfortunately receiver doesn't receive correct data with sw uart and device doesn't work.
...

Hi,

I tryed the code you suggested me, but it's the same. Pin B5 continue to be H. no way to put it L. I saw I can put it L only using Software UART. Using FORCE_SW statement in #USE_RS232.

But ...

Hi,

I've the same problem with 16F88 and compiler version 3.242.

I made as you suggest in my code but pin B5 is always high. it is output and it is connected to the same component connected to p ...

Hi,

I configured my PIC16F88 with hw uart. I need only RX pin and i'd like to use TX pin as Output.

Is it possible to do?

I found some problems, because if i set TX pin as Uart TX my device ...

the problem is that i'm driving leds only on or off. not in PWM. i can't understand why it seems PWM.

whisper as a vibration....... as an audible frequency switching in leds. Their luminosity decreases too in that case.as it is driven by PWM.
not audio device. The same happen with 16F88.

Leds on R ...

My circuit is:5V 10K pullup to RA4, from it a series 2,2kohm resistor to NPN Base, NPN Emitter to GND and Collector to led katode. 2 or more led columns from 5V. it's simple. Ra4 doesn't reach 0.8VDD ...

I had already read that tread.
I was also wondering which is the best use for RA4, input or output?
I'm using a transistor to drive led, so pin not directly on led. Is there a way to solve this pro ...